im new to FPGA programming and i bought a QMTech cyclone V board which is supposed to be a clone of DE10 nano. There are 4 dip switches and i programmed them to turn on the LEDs when they are switched but when i upload the code to this board and turn on a switch, the whole FPGA board gets reset. How can i fix this issue please help.
Cannot configure QMtech dip switches
-
sachintha2000
- Posts: 1
- Joined: Thu Nov 21, 2024 10:08 am
-
andrezheng
- Posts: 32
- Joined: Tue Aug 25, 2020 3:10 pm
- Has thanked: 1 time
- Been thanked: 6 times
Re: Cannot configure QMtech dip switches
Please don't switch these switches when board is powered on. They are using shorting switches.
Please check the shorting and non-shorting switches in the attached image.
- Attachments
-
- E8C7DD2D046EC706BB46BA58861D47A2.jpg (150.96 KiB) Viewed 162 times