Kung Fu Master Core Broken?

[kaz321123]

Used to work, now doesn't.

It boots, and then blacks out after about 3 seconds. Other arcade cores still work (just to make sure it wasn't system wide or something).

My setup: vga to component, retail crt.

Anyone else have this issue?

[MostroW]

just did a run up to 2nd boss and game worked fine for me, updated my setup a few days ago and 0 issues.
maybe try to reupload the rom to your storage device?

[Yunaiba]

Does this game need any special config for playing on a CRT TV?
Rest of games work fine but Popeye and Kung Fu Master don't.

[Lightwave]

Kung Fu Master runs at around 50hz on my VGA CRT, does your TV support that frequency?

[kaz321123]

Works fine on my hdtv. It blacks out a couple times, but eventually loads. I just have to fiddle with it. It has played on my crt before. I know how to tweak the ini a bit better now.

I did upload the exact rom version. 223 I think. And deleted the cfg just in case.

[kaz321123]

Does this game need any special config for playing on a CRT TV?
Rest of games work fine but Popeye and Kung Fu Master don't.

If it seems to 'not be working', just give the game a good solid minute- and it might still load. Just brainstorming.

[Yunaiba]

Hi! Made it work!! Thanks a lot.

[Tofana10am]

So what was the solution? I’ve got terrible screen tearing. Looks like a resolution problem with the various CRT settings (e.g. frequency, back porch, etc). Thanks for any help. I’m using a Sony WEGA 27” CRT connected via component through the MISTER IO board.

Thanks,
Bret