No power to USB Board

[Washac]

Just fitted my MiSTerFPGA USB board fitted the link and powered on, tried a usb device but it has no power.

Seems there is no power getting to the USB hub board.

Any ideas or a dodgy board or power link ?

[Threepwood]

The USB board has a tiny fork that touches a solder point right behind the DC-IN of the DE10-Nano. The USB board has power when the red LED at the back end (the side the DC-IN is located) is lit.

Make sure this fork has contact.

[Nat]

The USB board has a tiny fork that touches a solder point right behind the DC-IN of the DE10-Nano. The USB board has power when the red LED at the back end (the side the DC-IN is located) is lit.

Make sure this fork has contact.

I think the above only applies to USB hub's produced by Ultimate MiSTer.

My suggestion is to just remove the board and re-seat the Micro USB connection you are using, also check the DC plug is firmly inserted into the DC socket on the hub, another tip for checking is you can connect the hub to a PC if required.

Also the sockets labelled PWR1 on the USB Hub v2.1 are for power only and not data, if you use these sockets no LED's on the hub will illuminate.

[Washac]

The USB board has a tiny fork that touches a solder point right behind the DC-IN of the DE10-Nano. The USB board has power when the red LED at the back end (the side the DC-IN is located) is lit.

Make sure this fork has contact.

Do not know what it was but I removed the board then put all back together and all OK, thanks for the pointer though

[rickdangerous]

Hi Washac, glad everything is now ok. Anything you need, just ask.
Was for sure the power pin not making contact.

Keep Safe, Enjoy MiSTer.