Loom
-
- Posts: 93
- Joined: Mon May 25, 2020 8:23 pm
- Been thanked: 4 times
Loom
I've tried 2 different iso's of Loom and the super CD boot pops up, but after that it's darkness. Is anyone able to run this one?
-
- Posts: 93
- Joined: Mon May 25, 2020 8:23 pm
- Been thanked: 4 times
-
- Core Developer
- Posts: 547
- Joined: Sun May 24, 2020 9:30 pm
- Has thanked: 20 times
- Been thanked: 145 times
Re: Loom
Not sure what you mean by "skips"...
But that title has a lot of things about it that look like bugs until you find out that they are also present in the original hardware. Real annoyances that don't make any sense.
But that title has a lot of things about it that look like bugs until you find out that they are also present in the original hardware. Real annoyances that don't make any sense.
-
- Posts: 93
- Joined: Mon May 25, 2020 8:23 pm
- Been thanked: 4 times
Re: Loom
Like stuttered cut scenes and music. Weird version though, think it's more based on the VGA release, but uses graphics sort of in between.
-
- Core Developer
- Posts: 547
- Joined: Sun May 24, 2020 9:30 pm
- Has thanked: 20 times
- Been thanked: 145 times
Re: Loom
The graphics are not so smooth, but the sound shouldn't be stuttering.
Are you network-mounting your image ? (network can add delays)
Are you using vsync_adjust=2 ? (this can cause video and audio issues)
Have you set CD Seek to normal or fast ? (this will make a non-original play experience)
If all of the above are normal (i.e. SDCard/vsync 0/normal CD), I would suspect your rip.
Are you network-mounting your image ? (network can add delays)
Are you using vsync_adjust=2 ? (this can cause video and audio issues)
Have you set CD Seek to normal or fast ? (this will make a non-original play experience)
If all of the above are normal (i.e. SDCard/vsync 0/normal CD), I would suspect your rip.
-
- Posts: 93
- Joined: Mon May 25, 2020 8:23 pm
- Been thanked: 4 times
Re: Loom
may be that vsync, think I left it off since using 15khz on 1084. using sd and cd seek is norm.
- Reverend Crush
- Posts: 13
- Joined: Mon May 25, 2020 3:28 pm
- Been thanked: 1 time