- 20220209_183245.jpg (686.35 KiB) Viewed 812 times
Image rising vertically non-stop!
-
marcelosofth
- Posts: 174
- Joined: Wed Sep 22, 2021 10:03 pm
- Location: Brazil - São Paulo
- Has thanked: 8 times
- Been thanked: 4 times
- Contact:
Image rising vertically non-stop!
Hello friends, I'm using a Digital I/O Board v1.2 with a "Vention HDMI to VGA Adapter" and a VGA to Component cable, the image is apparently ok, but the image is climbing vertically without stopping, does anyone have a solution?
-
FoxbatStargazer
- Top Contributor
- Posts: 1019
- Joined: Thu Dec 10, 2020 5:44 pm
- Has thanked: 315 times
- Been thanked: 238 times
Re: Image rising vertically non-stop!
If it's just a VGA to component passive breakout cable, you don't have any sync signal passing through to the TV. The H/V sync from VGA is just being ignored by a breakout cable. You need to get Sync on Green into the signal of the green (luma) cable somehow, which usually involves some kind of active circuit.
The Mister analog I/O boards provide SoG function, which is usually the easiest way to do that. There doesn't seem to be any way to have the Mister add it to its own HDMI out. Some more knowledgeable people might be able to help you with another approach. In theory an HDMI->component converter should do the job but some have had trouble with that too.
The Mister analog I/O boards provide SoG function, which is usually the easiest way to do that. There doesn't seem to be any way to have the Mister add it to its own HDMI out. Some more knowledgeable people might be able to help you with another approach. In theory an HDMI->component converter should do the job but some have had trouble with that too.