HDD Enclosure for Print in 3D

Showcase builds, discuss cases, embedding MiSTer into existing computer cases.
Post Reply
peke
Posts: 89
Joined: Thu Feb 17, 2022 6:55 pm
Has thanked: 3 times
Been thanked: 3 times

HDD Enclosure for Print in 3D

Unread post by peke »

hi. I'm going to use a hdd on the mister. are there any 3d case files for fitting an hdd?
Top
AngelicLiver
Top Contributor
Posts: 433
Joined: Fri May 29, 2020 8:50 am
Has thanked: 86 times
Been thanked: 120 times

Re: hdd enclosure for print in 3d

Unread post by AngelicLiver »

If you're using a usual MiSTer 'stack' style config there's the MASE, Retro Frog has not released the files though as far as I know.

You could just use any off-the-shelf enclosure or any number of the ones available on Thingiverse, unless you have a specific mounting requirement?
Top
peke
Posts: 89
Joined: Thu Feb 17, 2022 6:55 pm
Has thanked: 3 times
Been thanked: 3 times

Re: HDD Enclosure for Print in 3D

Unread post by peke »

Some like that. I think I will use WD my passport ultra.
Top
Post Reply

Return to “Hardware Setups”