Flashing Red / Amber LED's After Installing IO Board v6.1

[elrubioVS]

My DE10 worked perfectly until I installed my IO Board. Now when I power-up I just get alternate flashing on the Red (Power) / Amber (User) LED's. The static/fuzz is displayed but I'm unable to get the OSD menu.

You can see here:

qmLp9U.gif (2.17 MiB) Viewed 13846 times

My setup is as follows:

• I'm powering my DE10 with a USB cable (https://www.amazon.co.uk/gp/product/B003MQO96U) connected to mains via a standard Apple USB plug.

• I've connected this IO Board 6.1: https://ultimatemister.com/product/i-o-board-6/

• I have a 128mb SDRAM module installed: https://misterfpga.co.uk/product/mister ... mb-module/

I'm thinking it may not be getting enough power. My DE10 came with a US plug so should I purchase this UK plug: https://www.amazon.co.uk/dp/B001CQ0HC2

Any advice would be appreciated!

[elrubioVS]

UPDATE: I've removed the IO board and wiped the MicroSD card. Reinstalled Mr Fusion and booted up but getting nothing from the display through HDMI at all. Tried a second MicroSD card with Mr Fusion and it's the same. No display.

Is there a way to flush/reset the DE10?

[elrubioVS]

UPDATE 2: I removed the SDRAM module and rebooted and I'm now seeing the "Mr Fusion is installing MiSTer" screen. Stay tuned.

[KnC]

My DE10 worked perfectly until I installed my IO Board. Now when I power-up I just get alternate flashing on the Red (Power) / Amber (User) LED's. The static/fuzz is displayed but I'm unable to get the OSD menu.

This is normal behaviour apart from the unable to detect the controller did you try a keyboard ?

[elrubioVS]

It's power supply related.

I was using a USB cable connected to the mains with an Apple 5W USB plug. This just gives me the flashing red/amber LED's.

If I use the exact same setup with the USB connected to a USB 3 port on my laptop then it works fine.

I need to purchase a proper power supply.

[FPGA64]

It's power supply related.

I was using a USB cable connected to the mains with an Apple 5W USB plug. This just gives me the flashing red/amber LED's.

If I use the exact same setup with the USB connected to a USB 3 port on my laptop then it works fine.

I need to purchase a proper power supply.

I would get the one from MisterFpga.co.uk

https://misterfpga.co.uk/product/mister ... er-supply/

much better power supply. Although do remember you need the mains to the power pack cable too

[elrubioVS]

I would get the one from MisterFpga.co.uk

https://misterfpga.co.uk/product/mister ... er-supply/

much better power supply. Although do remember you need the mains to the power pack cable too

Perfect thanks! I must admit I was nervous about blowing up my DE10

[annette]

Do not buy a replacement 2amp supply try to get a 4amp supply.

[Defender]

@elrubioVS has the flashing stopped after replacing the PSU please? Or is it just a normal behaviour?

[rhester72]

My DE10 worked perfectly until I installed my IO Board. Now when I power-up I just get alternate flashing on the Red (Power) / Amber (User) LED's.

This is by design - MiSTer does this on startup. You didn't see it before because you didn't have a board with the LEDs.