update_all and arcade offset

[billythefisherman]

Hi all, so I can't get the update_all.sh terminal working on my setup.

IfI turn on fb_terminal it says I need to turn on vga_scaler and if I turn that on it makes my CRT (sony PVM 2730QM) image completely garbled.

So I'm left with skipping the settings menu which normally is fine, however I now want to enable 'arcade offset' setting by Atrac17 but because of the above I can't.

I tried downloading Atrac17 arcade_offset_update.sh (fromthe github) and running that but it just exits instantly doing nothing.

I'm sure all the settings menu arcade offset option does is just add a bit of text into the downloader.ini file if someone would be kind enough to post that bit of text that would be great!

Thanks all for any help

[FPGA64]

My bet is you have downloaded HTML from github and not the script. Download using the raw option on Github

[billythefisherman]

Good shout - why on earth does GitHub make that so easy and the downloading the actual version so hard. I did clone the GitHub repository but I might have tried quickly downloading just the script. Anyway I'll check! Thanks

[billythefisherman]

So turns out I have done everything right in terms of .sh file (I just couldn't quite remember). So either I need to do something else for that to work or get the piece of text the settings menu puts into the downloader.ini.

I notice in the repository there are 'roms', 'release' and 'readme' folders but no instructions (as far as I can see) where should they be put (this is complicated by the fact I have all my roms on a usb device and all my mra's on the memory card).