All,
I just bought the newest Mister Aluminum case and found out that the case is made for the short USB Bridge board but I have the long bridge board. My USB hub uses the USB connector and not a barrel connector. If I buy a short USB bridge board will it fit on my current USB Hub or do I have to buy a new USB hub that comes with the short USB bridge board to make it fit into the case?
You need a USB hub like this as show on the metal case product page. So I think you will need a new complete new USB hub if you wish to use this case type.
Requires a USB hub with DC power jack and USB bracket. If you don’t have a USB bracket, please ensure you have header pins behind the micro USB port.
I don't have the USB bracket on mine. Other problem is the 14mm stand off is also too long because I think of my board so I can't fit the screw under the case to put on the top either. I hope the seller will let me return the case.
if you are good at soldering you would simply need to remove the power in USb and replace it with a barrel jack. Solder in the header in front of the micro USb and get hold of one of the internal bridges
