Page 2 of 2
Re: DIY Spinner Controller
Posted: Wed May 03, 2023 1:10 pm
by MrChatouille
metalfacemark wrote: ↑Wed May 03, 2023 1:03 pm
hellbent wrote: ↑Sun Nov 06, 2022 6:26 pm
here is the code as i used it. it was tweaked for my button inputs.
Code: Select all
/* Arcade Spinner v0.7
* Copyright 2018 Joe W (jmtw000 a/t gmail.com)
* Craig B - Updated code for mouse movement modes(DROP, ACCM) and case statement for Button port bit validation
}
Is this for mister.ini ? I have a spinner but i cant get it to register on the mister.
This looks like the code to program an arduino.
Which spinner did you have ?
Re: DIY Spinner Controller
Posted: Wed May 03, 2023 2:14 pm
by metalfacemark
its just a random usb one i picked up online.
Re: DIY Spinner Controller
Posted: Wed May 03, 2023 2:22 pm
by metalfacemark
Ah i found it
; use specific (VID/PID) mouse X movement as a spinner and paddle. Use VID=0xFFFF/PID=0xFFFF to use all mice as spinners.
; spinner_throttle with base value 100 gives one spinner step per one tick. Higher value makes spinner slower.
; Lower than 100 makes spinner faster. Negative value gives opposite direction.
;spinner_vid=0x1BCF
;spinner_pid=0x0005
;spinner_throttle=-50