Page 1 of 1
Why Do My Posts Need To Be Approved? Why Can I Not Send Private Messages?
Posted: Sun Aug 23, 2020 9:36 pm
by Xbytez
If you are a newly registered user on the MiSTer FPGA forum, your first post will require review and approval before being published.
Until you reach this qualifying number of posts you are unable to post freely or use the private messaging system.
This new user post approval system is in place to reduce spam on the forum, and private message system abuse.
Re: Why Do My Posts Need To Be Approved? Why Can I Not Send Private Messages?
Posted: Sat Aug 29, 2020 9:04 am
by buttersoft
Rgr, thx, and sorry to be a pain!
Re: Why Do My Posts Need To Be Approved? Why Can I Not Send Private Messages?
Posted: Sat Aug 07, 2021 10:43 pm
by Chopin
Xbytez wrote: ↑Sun Aug 23, 2020 9:36 pm
If you are a newly registered user on the MiSTer FPGA forum, your first 2 posts will require review and approval before being published.
Until you reach this qualifying number of posts you are unable to post freely or use the private messaging system.
This new user post approval system is in place to reduce spam on the forum, and private message system abuse.
I've actually made four or five comments now, and post approval is still turned on for me. Did the minimum number change?
Re: Why Do My Posts Need To Be Approved? Why Can I Not Send Private Messages?
Posted: Sun Aug 08, 2021 8:27 am
by Xbytez
No, it is still two.
However the forum software does not synchronize new user total post counts in real time, so it can take a up to an hour or so before your true post count is shown.