MiSTer FPGA Forum

Hello! I'm assembling a Digital I/O Board v1.2. Since I lack a lot of components I want to use it anyway just for the fan, so I'm mounting these components:

• P1, P2, P6 and P7 pin headers
• C1 (10uF)
• F5V / F3V as a 3 pin header (to use with a jumper)
• DPDT switch turned ON (POWER)
• FAN connector

Apart from turning SW3 to ON on the DE10-Nano, am I missing something? I just want to be sure before blowing my beloved hardware.

Soldering J2 and P2 can I get line level analog audio?

I'm kinda new at this but I think you just need:
P1 pin header
C1 (10uF)
F5V / F3V as a 3 pin header (to use with a jumper)
FAN connector

Also, if you're not going to populate the power side down the road, you can just short the F3V side of the jumper header with some solder since I believe it will only pull up 3.3V from the DE10 Nano.