MiSTer FPGA Forum

Hi,

After successfully installing the ET4000+ drivers and switching to 800x600, is there a way to get a better display through HDMI ?

The characters are difficult to read, they are not clearly drawn.

Is there a trick to make it sharp ?

Does selecting a different monitor may help improving the display ?

Regards.

Have you tried a higher resolution "video_mode=" in the [ao486] section in you MiSTer.INI?

Maybe 800x600 is being scaled into 640x480...

https://github.com/MiSTer-devel/Main_Mi ... MiSTer.ini

Yes, this was the trick, I didn't know that the MiSTer.ini could have sections for specific cores, thank you for your help !