Connect USB board to DE10 Nano using pins

Discussion of official MiSTer Project addons. (https://github.com/MiSTer-devel/Hardware_MiSTer)


Post Reply
deepthaw
Posts: 65
Joined: Wed May 27, 2020 3:45 am
Has thanked: 1 time
Been thanked: 13 times

Connect USB board to DE10 Nano using pins

Unread post by deepthaw »

I think the microusb port on my USB board has gone bad. Is it possible to use the jumper pins near it to connect to the DE10 Nano instead?

How would I wire up that cable?
Top
User avatar
venice
Top Contributor
Posts: 788
Joined: Tue Jun 16, 2020 9:29 am
Location: Germany
Has thanked: 278 times
Been thanked: 278 times

Re: Connect USB board to DE10 Nano using pins

Unread post by venice »

deepthaw wrote: ↑Fri Nov 27, 2020 12:23 am I think the microusb port on my USB board has gone bad. Is it possible to use the jumper pins near it to connect to the DE10 Nano instead?

How would I wire up that cable?
These jumpers (v2.1 Board)?
Jumpers.png
Jumpers.png (306.65 KiB) Viewed 4092 times
I power my board with the "normal" power connector J1 and use the pins of P1/P2 for the data connection.
Schema.png
Schema.png (53.05 KiB) Viewed 4092 times
Got an Micro USB to 5pin cable from Ali and modfied it a bit.
cable.png
cable.png (23.71 KiB) Viewed 4089 times

My MiSTer Add-On-Projects tty2oled, i2c2oled, SNAC2IEC
You can donate by sending a Postcard (Cardwarez) to me.

Top
g00bak
Posts: 5
Joined: Sat Jun 22, 2024 4:53 pm

Re: Connect USB board to DE10 Nano using pins

Unread post by g00bak »

My usb board does not have the pins. Any link on how to add them?

Top
Post Reply

Return to “Official Project Addon Boards”