Page 1 of 1
Connect USB board to DE10 Nano using pins
Posted: Fri Nov 27, 2020 12:23 am
by deepthaw
I think the microusb port on my USB board has gone bad. Is it possible to use the jumper pins near it to connect to the DE10 Nano instead?
How would I wire up that cable?
Re: Connect USB board to DE10 Nano using pins
Posted: Sat Dec 12, 2020 3:05 pm
by venice
deepthaw wrote: ↑Fri Nov 27, 2020 12:23 am
I think the microusb port on my USB board has gone bad. Is it possible to use the jumper pins near it to connect to the DE10 Nano instead?
How would I wire up that cable?
These jumpers (v2.1 Board)?
- Jumpers.png (306.65 KiB) Viewed 5202 times
I power my board with the "normal" power connector J1 and use the pins of P1/P2 for the data connection.
- Schema.png (53.05 KiB) Viewed 5202 times
Got an Micro USB to 5pin cable from Ali and modfied it a bit.
- cable.png (23.71 KiB) Viewed 5199 times
Re: Connect USB board to DE10 Nano using pins
Posted: Sat Jun 22, 2024 8:16 pm
by g00bak
My usb board does not have the pins. Any link on how to add them?