If I want to use the DB-15 on the I/O board for analog out to an arcade monitor, do I leave vscale_mode set to 0?
I want all games to display in their native resolution & refresh rate.
Thanks!
Question about vscale_mode
-
FoxbatStargazer
- Top Contributor
- Posts: 1019
- Joined: Thu Dec 10, 2020 5:44 pm
- Has thanked: 315 times
- Been thanked: 238 times
Re: Question about vscale_mode
vscale_mode only applies to the scaler, so if vga_scaler=0 its not relevant to your arcade monitor.
If you are using vga_scaler=1, generally vscale_mode=2 will work with CRTs and deliver minimal lag. 1 will sometimes stabilize cores that are dropping signals, while 0 can be used to force 60 hz or something close to it if your display can't handle the core's true refresh rate.
If you are using vga_scaler=1, generally vscale_mode=2 will work with CRTs and deliver minimal lag. 1 will sometimes stabilize cores that are dropping signals, while 0 can be used to force 60 hz or something close to it if your display can't handle the core's true refresh rate.