Page 1 of 1
Question about vscale_mode
Posted: Wed Dec 23, 2020 12:51 pm
by tonyt76
If I want to use the DB-15 on the I/O board for analog out to an arcade monitor, do I leave vscale_mode set to 0?
I want all games to display in their native resolution & refresh rate.
Thanks!
Re: Question about vscale_mode
Posted: Thu Dec 24, 2020 4:55 am
by FoxbatStargazer
vscale_mode only applies to the scaler, so if vga_scaler=0 its not relevant to your arcade monitor.
If you are using vga_scaler=1, generally vscale_mode=2 will work with CRTs and deliver minimal lag. 1 will sometimes stabilize cores that are dropping signals, while 0 can be used to force 60 hz or something close to it if your display can't handle the core's true refresh rate.