Are the lights supposed to be green and red, while the mister is running?
Addon Board - Lights Color
-
Nat
- Posts: 129
- Joined: Sun May 24, 2020 7:28 pm
- Location: United Kingdom
- Has thanked: 9 times
- Been thanked: 70 times
- Contact:
Re: Addon Board - Lights Color
If you have the analog IO board v6.1 you can cut this trace on the underside of the circuit board, this will disable all three coloured status LED's to enable them again you will need to bridge the trace again.
On the boards I build, I just cut the trace and install a 2 pin header on the top side of the PCB and add a jumper cap, this allows for quick and simple enable/disable of your IO board status LEDs when needed.
- io-v6-1-board-disable-LEDs.png (250.11 KiB) Viewed 3546 times
MiSTer FPGA Add-On Boards : UK based, low cost worldwide shipping.
https://MiSTerFPGA.co.uk/
-
chanunnaki
- Posts: 105
- Joined: Tue Jul 07, 2020 1:33 am
- Been thanked: 19 times
Re: Addon Board - Lights Color
I just discovered this little feature of your board. Much appreciated!Nat wrote: ↑Sat Mar 27, 2021 6:29 pmIf you have the analog IO board v6.1 you can cut this trace on the underside of the circuit board, this will disable all three coloured status LED's to enable them again you will need to bridge the trace again.
On the boards I build, I just cut the trace and install a 2 pin header on the top side of the PCB and add a jumper cap, this allows for quick and simple enable/disable of your IO board status LEDs when needed.
io-v6-1-board-disable-LEDs.png