Page 1 of 1
Xinput on JPAC crashes MiSTer
Posted: Fri May 07, 2021 5:13 pm
by Escape-To-88
Can't figure this one out. On a JPAC latest firmware 1.55. Keyboard mode (mode 1) works fine, no issues apart from the Robotron twin sticks problem. I switch to mode 3 Xinput and the setup will let me set up the stick no issues as soon as I tap any button at all the MiSTer freezes and I have to reset it. This issues happens on the menu and in-game. I have the correct VID and PID ids and I've checked several times and had no luck. Oddly without any ids at all, if I remove them for instance everything still work in Xinput mode, again except when I press any button. Anyone have any ideas what is happening here?
Re: Xinput on JPAC crashes MiSTer
Posted: Sat May 08, 2021 8:53 am
by Escape-To-88
Anyone? Mode 1 keyboard input is fine, I just can't map two sticks, so no Robotron. Mode 3 crashes with button presses.
Re: Xinput on JPAC crashes MiSTer
Posted: Thu May 20, 2021 10:48 pm
by mhartman
I just bought a jpac and have the same issue.
Re: Xinput on JPAC crashes MiSTer
Posted: Fri May 21, 2021 5:43 pm
by mhartman
To follow up, I reverted to an older version of the mister software (10/2020) and got everything working. Not sure why the new version crashes it.
Re: Xinput on JPAC crashes MiSTer
Posted: Fri May 21, 2021 5:51 pm
by zakk4223
Does it work with today's mister release? I noticed there was a commit a few days ago specifically addressing a crash related to jamma devices
Re: Xinput on JPAC crashes MiSTer
Posted: Sat May 22, 2021 1:31 am
by mhartman
zakk4223 wrote: ↑Fri May 21, 2021 5:51 pm
Does it work with today's mister release? I noticed there was a commit a few days ago specifically addressing a crash related to jamma devices
Good catch. I’ll do an update and report back.