MiSTer FPGA Forum

Dear all

The volume output through the HDMI cable is low. Even with the volume output on the TV at its maximum, i have a poor sound coming from the mister.

is it possible to increase the sound level for the HDMI cable ?

Best regards.

Phil

In OSD you have page where you can check if volume is max.
Some cores may generate lower volumes, but in general volume is good.

I have some computer speakers connected to the audio out jack because HDMI audio varies by core.
Lately it has been much better but some are very loud, others moderate, and some none.
This setup gives me audio no matter what but as stated already, in general volume is good.