Can't connect to modem in C64 core in CCGMS

[boilop]

I am using CCGMS ultimate and I have the following settings:

- Systerm rom: Standard C64 (for RS232 support)
- RS232 mode: UP9600
- RS232 connection: Internal

- UART mode: modem, TCP link, 9600 baud


In CCGMS ultimate, with "F7", I changed the modem type to UP9600

When I try to type 'for instance "ATHELP', nothing happens, as if I were not connected to anything at all, so it seems like I can't even talk to the internal modem at all.

[bbond007]

When I try to type 'for instance "ATHELP', nothing happens, as if I were not connected to anything at all, so it seems like I can't even talk to the internal modem at all.

Which kernal ROM are you using?

From WIKI:

"Note: DolphinDOS and SpeedDOS kernals have no RS232 routines so most RS232 software don't work with these kernals!"

[rcade]

I tested my setup again today with JiffyDOS ROM and CCGMS 2021. Worked fine... UART set to UP9600 modem mode.

[boilop]

When I try to type 'for instance "ATHELP', nothing happens, as if I were not connected to anything at all, so it seems like I can't even talk to the internal modem at all.

Which kernal ROM are you using?

From WIKI:

"Note: DolphinDOS and SpeedDOS kernals have no RS232 routines so most RS232 software don't work with these kernals!"

I used the standard system rom, i.e. the official C64 one (as mentioned above).

[boilop]

I tested my setup again today with JiffyDOS ROM and CCGMS 2021. Worked fine... UART set to UP9600 modem mode.

I haven't tried with JiffyDOS, just with the normal kernal, I can give it a shot. Interesting that CCGMS 2021 worked for you, the wiki explicitly said to not use it and that it's buggy.

Let me try with CCGMS 2021, thanks!

[boilop]

No dice for me, still.

- In CCGMS, you do press "F7" and select "UP9600" as model type, but keep Baud Rate to 2400?
- In Mister, in "hardware" menu, RS232 is UP9600 and "internal" and UART mode is modem, TCP at 9600 bauds?

Thanks!

[rcade]

No dice for me, still.

- In CCGMS, you do press "F7" and select "UP9600" as model type, but keep Baud Rate to 2400?
- In Mister, in "hardware" menu, RS232 is UP9600 and "internal" and UART mode is modem, TCP at 9600 bauds?

Thanks!

Set CCGMS to 9600 also if you are using UP9600 mode.

Once you do that, you can issue ATDTipaddress:port

Of course, Ethernet must be connected. Or possibly Wifi, but I don't connect mine that way.