Page 1 of 1
Delayed scrolling after attempting the latest update.
Posted: Sat Sep 11, 2021 2:31 am
by Captain FPGA
So I finally updated my Mister to the new linux version, I'm told I needed to use just regular update first and then update all to avoid any problems so I did that. I haven't hit update all yet because the scrolling mechanism is screwed on my Mister OSD. I would hit down/up and it would be slow. How to correct?
Re: Delayed scrolling after attempting the latest update.
Posted: Sat Sep 11, 2021 2:35 am
by zakk4223
If you have a Blister board, update the firmware.
https://www.youtube.com/watch?v=VK39W--vClc
Re: Delayed scrolling after attempting the latest update.
Posted: Sat Sep 11, 2021 6:10 am
by Captain FPGA
It won't even let me navigate into the script folder.
Re: Delayed scrolling after attempting the latest update.
Posted: Sat Sep 11, 2021 8:26 am
by annette
Just boot up mister then unplug and plug back in your usb keyboard, the keys will work fine for a few seconds, quick navigate to do the update, if the keyboard stops again, just unplug and plug in keyboard again till you can navigate and run the blisster update script, thats what i did no problems after updating firmware but remember to update both blisster ports.
Re: Delayed scrolling after attempting the latest update.
Posted: Sat Sep 11, 2021 8:27 am
by FPGA64
SSH into the Mister and run the scripts remotely would be one option.
Re: Delayed scrolling after attempting the latest update.
Posted: Sat Sep 11, 2021 9:43 am
by Captain FPGA
annette wrote: ↑Sat Sep 11, 2021 8:26 am
Just boot up mister then unplug and plug back in your usb keyboard, the keys will work fine for a few seconds, quick navigate to do the update, if the keyboard stops again, just unplug and plug in keyboard again till you can navigate and run the blisster update script, thats what i did no problems after updating firmware but remember to update both blisster ports.
This suggestion helped my navigation for a short time like you said. I was finally able to access update all script. Problem is my wifi is acting up again. I'll wait until it corrects itself or something before I try to go back in.
Re: Delayed scrolling after attempting the latest update.
Posted: Sat Sep 11, 2021 10:27 am
by FPGA64
There is always the option of a wired connection. Assuming your mister is close to the router
Re: Delayed scrolling after attempting the latest update.
Posted: Sat Sep 11, 2021 7:39 pm
by twotone8
Captain, the update_all script isn't actually what you're looking for here. You'll need to update the firmware on both BlisSTer ports to resolve the issue. I made a video (just over a year ago) explaining the process if you want to have a look.
https://www.youtube.com/watch?v=VK39W--vClc
You will need a stable internet connection to your MiSTer to get it to work though.
Re: Delayed scrolling after attempting the latest update.
Posted: Sun Sep 12, 2021 1:30 pm
by Bear
I've had the same problem. I thought it was my card, so I wiped and did a clean install.
Updated BlisSTer firmware, but I've still got an issue with scrolling, and the clock will sometimes miss a second while it's missing input. It also takes a while to get an IP. Any other suggestions? The MiSTer isn't usable in its current state.
Thanks!