MiSTer FPGA Forum

I find the power switch on the BlisSTer v2 too short and difficult to press when inside a case.

Is there a solution for this?

Perhaps someone has found a different switch or a way of extending the length of the button?

When the going gets tough by populating too many ports on your BlisSTer™ (as I am) in a way your fat thumb can't firmly press on the switch (as I can't), you have a choice of:

• growing your pinky fingernail (also serves to clear earwax eeww gross),

• using a pen/toothpick,

• gluing some trinket on the button face with superglue.

Or, you could look at this extra long cap

Cheers, does this just push over the top of the existing?