Page 1 of 1
Lights on the MiSTer do not light up
Posted: Thu Jun 04, 2020 9:16 pm
by MorkMikael
When do the lights on the MiSTer light up mine is all ways dark its the same with the red light (+FAN ) near j2. got the IO Board XL v6.1 with Noctua fan. Using the power brick that was with the de-10 Board. Do i need a better power brick or is the a jumper on the IO Board i'm missing.
Re: Lights on the MiSTer do not light up
Posted: Tue Jul 14, 2020 6:02 pm
by barfood
I found my LEDs would not light up when the SD card was not inserted. Is your MiSTer working fine while the LEDs are not turning on?
Re: Lights on the MiSTer do not light up
Posted: Tue Jul 14, 2020 6:50 pm
by Nat
Check the jumper cap is present on the two pin header marked P3, if your IO board builder cut the trace on the board, this needs to be present to enable the three status LEDs.