Hi
I’m unable to get sound through the 3.5 jack of the DigitalIO board v1.2
The led behind the jack is off.
I don’t know if there a setting in the ini file that maybe I’m missing
No sound in Digital IO board v1.2 through 3.5mm jack
-
Nat
- Posts: 129
- Joined: Sun May 24, 2020 7:28 pm
- Location: United Kingdom
- Has thanked: 9 times
- Been thanked: 70 times
- Contact:
Re: No sound in Digital IO board v1.2 through 3.5mm jack
It sounds like you need to setup the switches correctly on the DE10-Nano. The 3.5mm jack is for optical audio out only.
I've a guide posted on my site see here Digital IO Board Installation Guide for the MiSTer FPGA
I've a guide posted on my site see here Digital IO Board Installation Guide for the MiSTer FPGA
MiSTer FPGA Add-On Boards : UK based, low cost worldwide shipping.
https://MiSTerFPGA.co.uk/
-
pacoarcade
- Posts: 72
- Joined: Mon May 25, 2020 8:41 am
- Has thanked: 75 times
- Been thanked: 13 times
- Contact:
Re: No sound in Digital IO board v1.2 through 3.5mm jack
According to misterfpga.co.uk that 3.5mm jack is for ADC In (Tape Input)
-
Nat
- Posts: 129
- Joined: Sun May 24, 2020 7:28 pm
- Location: United Kingdom
- Has thanked: 9 times
- Been thanked: 70 times
- Contact:
Re: No sound in Digital IO board v1.2 through 3.5mm jack
The 3.5mm jack socket is dual purpose, it can be used as an optical audio output, or can be used as an ADC input.pacoarcade wrote: ↑Sat Jun 06, 2020 6:42 pm According to misterfpga.co.uk that 3.5mm jack is for ADC In (Tape Input)
MiSTer FPGA Add-On Boards : UK based, low cost worldwide shipping.
https://MiSTerFPGA.co.uk/