MiSTer FPGA Forum

Hello,
I've been able to assemble SNAC (USB version) and all the controller adapter, everything is working but there are a couple of things that are unclear and I wasn't able to find an answer on the web.

1) The JST X1 connector (not the jumper) on the SNAC PBC what is meant for?
2) On the Atari 2600 adapter how do I use the female jack?
3) On the Atari 2600 adapter what's the difference between leaving "7GPIO" closed or opened?

Thank you in advance

If I remember correctly the jack is used in combination with the ADC (analog input) board to support paddles.

sk8er000 wrote: ↑Fri Nov 12, 2021 4:17 pm The JST X1 connector (not the jumper) on the SNAC PBC what is meant for?

I too have been wondering about that

What is it for? :mystery: