MiSTer FPGA Forum

Hi,

when i am using Mister Input Tester Utility only horizontal movement of left Analog Stick is recognized, no vertical. Right Analog Stick no movement at all. Same behavior in games which support analog input.

When defining Joystick buttons globally in Mister, the movements for Right and Down for both analog sticks are recognized when asked for Stick 1/2 Test: Tilt RIGHT. I dont map the Sticks for that Tilt, is skip this Tilt Mapping.

Tried all Start+Button Modi but this is only for BT, my controller is USB wired.

Checked this behavior with an XBox360 Wireless Controller + Receiver -> same behavior as SN30 pro.

What i am doing wrong?

You probably exited the joystick setup too early. You need to go past the mouse and keep going. It will ask about the analog sticks a second time.

Thank you!

Indeed, that was one issue. Another issue was, that at start of mapping you have to press analog sticks RIGHT and DOWN when asked for Stick 1 (left) and 2 (right) Tilt RIGHT and DOWN. After mapping mouse actions there is again mapping for Stick 1 Tilt RIGHT and DOWN (why?) where you have to press left analog stick RIGHT and DOWN. Then mapping is complete and both analog sticks working good in Inputtest Utility and games.