Mt32-pi zero, no sound.

[Karmeck]

So I bought this, supposedly pre-configured.
https://ultimatemister.com/product/mt32 ... or-mister/

And plugged it in, but get no midi sound. Using the Ao486 shareware pack. No sound without the mt32-pi either.

Trying to play some music in the built in midi player, the osd works and the bars jump up and down. So music is playing. But I hear nothing.

I had the fortune to have a few pins missing on my 6.1 io board. But I fixed pin 10. My understanding is that pin 3 is not needed.

l8iryhM.jpeg (895.61 KiB) Viewed 1684 times

pCobfgQ.jpeg (1.07 MiB) Viewed 1684 times

[espo83]

Do you see it in the OSD in the Ao486 core?

[Karmeck]

Do you see it in the OSD in the Ao486 core?

Yes.

[rhester72]

Resolder all 9 P7 connection points *and* all 9 USB 3 connection points on the I/O board. Trust me.

[bbond007]

And plugged it in, but get no midi sound. Using the Ao486 shareware pack. No sound without the mt32-pi either.

Trying to play some music in the built in midi player, the osd works and the bars jump up and down. So music is playing. But I hear nothing.

did you set this in the mt32-pi.cfg?

Code: Select all

[audio]
output_device = i2s

[Karmeck]

And plugged it in, but get no midi sound. Using the Ao486 shareware pack. No sound without the mt32-pi either.

Trying to play some music in the built in midi player, the osd works and the bars jump up and down. So music is playing. But I hear nothing.

did you set this in the mt32-pi.cfg?

Code: Select all

[audio]
output_device = i2s

I have yet to check this. Bought it from ultimatemister, and it's described as a pre-configured. Will have to check configuration file tomorrow.

[Karmeck]

Possible issue has been identified.

The previous owner of this mister clearly did no use the serial port.

I have no jumper between the pins next to the serial port. Clearly this is standard issue on any newly purchased board, but with missing pins to being with, I guess this io board was not bought from any reputable seller.

NWuALqx.jpeg (162.7 KiB) Viewed 1685 times

[Mr. Encyclopedia]

I had a similar problem with my IO board, the SNAC port was missing the pins connecting it to the DE-10 nano. This seems to be a very common problem with boards bought from unknown sellers; I bought a MiSTer daughterboard kit from Amazon and have had problems with nearly every piece.

[Karmeck]

Putting the jumper back on the pins in the image above, solved the issue.

Psa: mt32-pi does not come with mt32 roms, as they are copyrighted. Thees are needed for munt/mt32 mode. Google and you find them.