No Video Out After Power Cycle

[DoubleA]

My Mister does not show any video after a power cycle, but everything else seems to work.
Thus SSH is possible and by running the reboot.sh script (from the Scripts folder), the Mister reboots and the video signal is restored in all it's glory afterwards! Till the next power cycle ...

How come? Any explaination for that strange behaviour?

Thanks for any insight on that matter ...

[DoubleA]

And wallpapers are not displayed. Pressing F1 does not rotate/cycle anything ...

[mrchrister]

Have you tried starting from scratch with another SD?

[DoubleA]

Have you tried starting from scratch with another SD?

Nope, because this would be the third time in 4 month. There must be a better solution than a "complete new setup" workaround.
It works for 2 or 3 updates after starting afresh, but then video out is gone again.

And i really do not understand why a simple reboot "solves" the problem. Isn't a power cycle a reboot+?
What's the difference that could trigger the problem?

[akeley]

Did you look into HDMI CEC issues?
viewtopic.php?t=2474
viewtopic.php?t=4699

[DoubleA]

Did you look into HDMI CEC issues?
viewtopic.php?t=2474
viewtopic.php?t=4699

Nope, cause i use analog/VGA out (but HDMI doesn't work, too)

[akeley]

Ah...analog...a small detail What are you conneting to and with what cable?

Instead of entirely new install, can you try with fresh mister.ini?

[Malor]

Are you storing your config dir on a different filesystem than the Mister binary?

Getting different results from cold versus warm boots can occur if the filesystem with the config directory doesn't come up right away. When you warm boot, it's there, and things suddenly work.

[DoubleA]

Ah...analog...a small detail What are you conneting to and with what cable?

You are right, i should have mentioned that before. Standard VGA cable/connector on both sides to a full-HD BENQ 20" LCD.

Instead of entirely new install, can you try with fresh mister.ini?

Did not try a fresh mister.ini. But how should that make a difference between cold and warm reboot?

[DoubleA]

Are you storing your config dir on a different filesystem than the Mister binary?

Nope, it's all on the same 128 GB micro-SD.

[Malor]

You mention that it works after a fresh install, but the behavior changes after a few reboots, so I'm thinking that maybe it's a setting you're changing that the monitor doesn't like. If a fresh mister.ini fixes it, that's almost certainly the problem.

Something is different between a fresh install and one that goes blank. It could be a setting, it could be a peripheral, it could be something about the monitor, it could be some behavior of yours that changes. Replacing mister.ini would be a way to rule that particular cause out.

A remote possibility is that the SD is somehow bad, and getting corrupted. Trying a reinstall on the card that came with your MiSTer might be a good troubleshooting step, albeit a painful one. If you bought the card from Amazon, you could have gotten a counterfeit, because of stock mingling. My mother got one that way; it claimed to be a 32 or 64G card, but it was actually a 2G card that endlessly overwrote itself when you went past 2G.

[newcgen]

I'm a first time user. Mr. Fusion boots OK and I see the install picture.
But after Mr. Fusion reboots, no HDMI signal is present.
the caps lock button works. The LED is on.

The MISTer.ini is present. Reboot via SSH doesn't help.

SD Cars is new Samsung and Linux from the manual works very well!