MiSTer FPGA Forum

Hey all,

I tried searching and didn't see any results. Perhaps I searched wrong.

I always had a stock a500 growing up so having a mister/minimig setup with hard drives and always on workbench is a dream come true. I am having some issues with my Asus PA248QV that is a 1920x1200 resolution monitor. I can't figure out how to add the modes to Picasso96 to support this resolution. Perhaps it's doable? Does anyone have this monitor or another 1920x1200 that could share a few config settings with me?

I figured it out

Added modelines to mister.ini
video_mode=1920,128,208,336,1200,1,3,38,193160

and then set them for NTSC and PAL in the [minimig] section

Then added a custom made via the tool. It just took me a few minutes to figure out how to use it.

I am trying to do this myself. However, I only get 640x480. Could you please show me your ini file?