PSX SNAC Adapter and Digital IO board

[lomdar67]

I bought one of these relatively cheap PSX SNAC adpaters on ebay (e.g. https://www.ebay.com/itm/385124081264).

On my Analog IO board the adapter works flawlessley, but on my Digital IO board (V1.2) it's not working at all.
"Normal" SNAC adapters work fine on the Digital IO board, so I assume it's the combination between the Digital IO board and the PSX SNAC adater.

Anyone any idea what the problem could be?

The Digiatal IO board has a jumper beside the SNAC port. Do I have to change this jumper to 3.3V?

[mike2411]

Hey not sure if this will solve your issue, but I had experienced something similar with my digital io board. I missed a step in the install process. There is a switch(SW3) on the DE10-Nano that has to be turned on for the new digital io board. Fortunately I was able to use a small screw driver to flip it on by going through the fan opening. Saved the stress on the board from having to pull it off the DE10-Nano again.


https://misterfpga.co.uk/mister-fpga-ho ... -io-board/

[lomdar67]

No, that's not the problem. The switch is configured correctly. But thanks for trying to help.

[venice]

Which “normal” SNAC Adapter is working?

The Digiatal IO board has a jumper beside the SNAC port. Do I have to change this jumper to 3.3V?

No, it must be set to IO.

[lomdar67]

Which “normal” SNAC Adapter is working?

This set here:

https://de.aliexpress.com/item/1005004272183863.html

[venice]

…and which Analog Board do you have?
A v6.1 Board?

//Edit
Where do you bought your digital board from?
Could you provide good quality pictures from the board?

//Edit2
Just tested my SNAC2PSX Adapter with my Digital Board 1.2.
No Problem here.