MiSTer FPGA Forum

Posted: **Wed Nov 16, 2022 4:44 pm**

Hi, I searched here in the forum and the old forum atari, but i did not find the mod made in version 6.0 of the IO board to run the genesis controls in SNAC.

If someone could show me exact location and what it takes to make the mod. My I/O board bought in 2019 with MisterAddons and I'm wanting to use SNAC on it without having to buy a new board.

Posted: **Thu Nov 17, 2022 7:41 pm**

I found a couple of examples on the internet of the modification for the v6.0 IO board. You just need two pieces of wire and a 100 ohm resistor, connect wires and resistor as shown in the images and cut the tracks on the PCB.

: image1.jpg (1.13 MiB) Viewed 2370 times

: image0.jpg (122.24 KiB) Viewed 2370 times

Posted: **Fri Nov 18, 2022 11:42 am**

Wow, thanks Xbytez

MiSTer FPGA Forum

Help I/O Board v6.0 Mod for SNAC for Genesis Controller

Help I/O Board v6.0 Mod for SNAC for Genesis Controller

Re: Help I/O Board v6.0 Mod for SNAC for Genesis Controller

Re: Help I/O Board v6.0 Mod for SNAC for Genesis Controller