MiSTer FPGA Forum

As the title states, I've noticed that when I configure the controls in the mister OSD, the coin and start buttons are "switched" with one another. Has anyone else experienced this?

It may be the case with some of the other Raizing cores too, but I've tested a few times just to make sure I'm not going crazy.

I'm using an 8bitdo sn30 pro.

Go into the OSD and set the controls as you normally would

up, down, left, right all working normally

I choose (start) for start and (select) for coin.

When in game i have to press (start) to coin up and (select) to start the game.

Just wondering if anyone else has experienced this. Not a major issue, but an issue to report nonetheless.

I suppose when you bind your keys for the game, when it prompts for coin press start and when it prompts for start press select and if it’s reversed it will work as you expect it.
Most arcade cores have bindings all over the board.