Page 1 of 1
Only CPS Cores Not Working With My Direct Video
Posted: Sun Aug 27, 2023 10:14 pm
by tekn0
Hello and thank you for any assistance on this. I have a very strange issue. I have a direct video set up going to component on a CRT and almost everything works perfectly, all console cores and almost all arcade cores are working perfectly except CPS 1 and 2.
When I load any CPS 1 or 2 arcade core, my screen signal drops and a loud buzzing sound plays. It happens with all CPS 1 & 2 cores /games. After this happen I need to hard reboot my mister.
Has any one experienced this before? I thought it was my ini but everything else is working perfectly.
Re: Only CPS Cores Not Working With My Direct Video
Posted: Mon Aug 28, 2023 5:16 pm
by rickdangerous
Check the SCANDOUBLER OPTION or delete core config to test.
Re: Only CPS Cores Not Working With My Direct Video
Posted: Wed Aug 30, 2023 12:06 am
by tekn0
rickdangerous wrote: ↑Mon Aug 28, 2023 5:16 pm
Check the SCANDOUBLER OPTION or delete core config to test.
Thank you for the suggestions. Unfortunately, I cannot access the scan doubler because my screen goes blank.
Did not see any core config's when I went in through the FTP for those cores.
I may give it a shot posting this in the display devices subform to see if there are other suggestions.
Re: Only CPS Cores Not Working With My Direct Video
Posted: Wed Aug 30, 2023 1:42 am
by tekn0
UPDATE: It's my adapter. I bought another one and it does not have this issue.
Does anyone know of another HDMI to VGA adapter that is compatible with the mister and supports audio out?