MiSTer FPGA Forum

Hello, I just purchased a JAMMIX and I have a Wells Gardner K7000 with the 9 pin (5 wires are used RGB + sync + ground).

How do I out to this from the JAMMIX? Is it via the jamma or via VGA out of the mister? If it’s via VGA do I splice the wires to the 9pin? Thank you in advanced!

The K7000 is a proper arcade monitor, so uses "4V" RGB levels. With a high input impednace of around 4K7, so definitely arcade style, It should work with the JAMMA edge on JAMMIX. You bought the monitor separately?

Thanks Rickdangerous, I will wire it up tomorrow to test out! I have the k7000 25” in an old arcade cabinet