MiSTer FPGA Forum

I had a kickstarter RoTate stand but never used my switch in tate mode. I had a laser bear iPad case for my mister but just had it propped on a wire stand. Why not smash them together?

Edited the stand stl up on printables to make it taller. Used switch mount stl to create a new vesa adapter plate to interface the stand with the vesa case.

Stand needs a heat-set insert in the bottom for the thumbscrew and you’ll also need some m4 bolts for the vesa adapter. I had flathead socket cap screws so that’s what I used.

Good job! That is a neat looking solution.

I bought a laserbear case and then bought ulanzi ipad VIJIM P001 stand hoping that both would fit - so I'm looking for an adaptor to merge the two or maybe a replacement stand.