Page 1 of 1
TI-99/4A - P-Code setup question
Posted: Sat Feb 17, 2024 3:43 am
by d97
I'm just wondering if there is a simple set of steps for getting UCSD pascal running on the TI99/4A core. I've done a little work in UCSD pascal on the Apple //e and would like to give it a shot on the TI. I've tried a couple of combinations but can't seem to get it to boot into the UCSD environment.
Can anybody give me the steps that I need to make it work?
Thanks
D.
Re: TI-99/4A - P-Code setup question
Posted: Sun Feb 25, 2024 12:14 am
by d97
FWIW - I figured out where my error was. I was using the wrong p-code.bin file. Put the Editor-Filer in Drive One, the Assembler and Linker in Drive Two and the Compiler in Drive Three. Link to the proper p-code.bin and throw the "use p-code" switch. For whatever reason, I seem to have to boot twice before I can use the editor. (The first boot gives me a "can't find the editor file).
D.