Page 1 of 1
OSD and RESET buttons (wired to GPIO pins) used to work.. now only work in some cores?
Posted: Sat May 18, 2024 11:28 pm
by iainjh
Hi
My Mister is in a custom case /keyboard and for simplicity have the OSD and RESET buttons wired from GPIO to momentary buttons. I use those frequently
I'm not sure when this happened, but I have realised some cores no longer respond when either hard buttons are pressed. AO486, spectrum, appleII etc,
However! - using PC engine, Atom, Electron, and many arcade cores the buttons work fine
I am assuming when I've updated in last weeks I've deleted or changed a mister.ini setting that enables this for some cores. Hopefully this can be re enabled but I cant find it.. can someone please advise what ini or other setting I need change to re enable these buttons in all cores?
thank you! 
Iain
Re: OSD and RESET buttons (wired to GPIO pins) used to work.. now only work in some cores?
Posted: Sun May 19, 2024 1:59 pm
by iainjh
hmm.
I found a backup iso of my microsd card, that I made last year.
I cant find any clues in the 2 x mister.ini's. and if I copy the OLD mister.ini to the current build, the buttons dont work.
if I copy the OLD rbf's over (I copied the old AO486 and appleII as a quick test)- the OSD and RESET buttons work again.
I've part answered by own question, I'll take a closer look at their own settings and will ask in the specific core sections. ta!
Re: OSD and RESET buttons (wired to GPIO pins) used to work.. now only work in some cores?
Posted: Sun May 19, 2024 2:45 pm
by FPGA64
Re: OSD and RESET buttons (wired to GPIO pins) used to work.. now only work in some cores?
Posted: Sun May 19, 2024 3:03 pm
by iainjh
thank you. I'll post there.
Nightmare if its been deprecated!
Cheers