Issue Connecting To CRT

[PlasticSkeleton]

I recently just got my preconfigured IO Direct MiSTer and the Mini Din-10 to YPbPr cable to connect it to the back of my old CRT. I downloaded the YPbPr .ini file from the github and made sure the switch on the side of the shell was switched to on as I assume that is the "sync on green" switch. I get this illegible static that scrolls vertically on my crt though and I am unsure why. I know the mister works and that the crt works, so I bet I am not understanding something with the config. Any advice is greatly appreciated!

[YoYo]

You can have up to four .ini set ups so first make sure it's using the correct one. You can select the different .ini using the controller. If you need to set up your controller do it via hdmi then switch back to the CRT.

MiSTer.ini Controller: Back + Right
MiSTer_alt_1.ini Controller: Back + Left
MiSTer_alt_2.ini Controller: Back + Up
MiSTer_alt_3.ini Controller: Back + Down

If the above doesn't work post your .ini file here and someone may be to look at and see what's happening.